The dimensions of the rear wheel rim and the width of the tyre are important for mounting I LOCK IT.
The distance between the lower edge of the rear wheel rim and the upper edge of the wheel (or mudguard) should be less than 105 mm and the tyre widths a maximum of 60 mm.
If you are not sure about the measurements, you can order a template free of charge from us in the I LOCK IT Shop. Basically, an already mounted, classic frame lock can usually be replaced by an I LOCK IT.
Most city, trekking and e-bikes have threaded bushings. On some models, these may be protected by plastic covers. These covers must be removed before mounting I LOCK IT.
- If no threaded bushings are available, you can use the I LOCK IT installation adapters+
- The installation adapters+ can also be used to compensate for frame strut widths of up to 10.5 cm
Mounting of I LOCK IT shown in the Video
I LOCK IT may only be mounted on the rear wheel. Mounting on motorbikes such as scooters, motorbikes or S-pedelecs (pedelecs with up to 45 km/h assistance) is not permitted.